LM311 Features and Technical Specifications

Provide the operating voltage for the Op-Amp. This pin can be used to turn off the output stageĬollector Out – This is the Collector output of the transistor This pin can be used to turn off the DC-offset voltage This pin is connected to the ground of the system (Negative voltage can also be used) The Inverting pin is also given a fixed voltage which is compared with the (IN+) The Non-Inverting Pin of the comparator is give a variable voltage to compare The output pin of this IC is PIN6.Emitter Output – This is the Emitter pin of the output transistor In Op-amp IC 741, PIN2 is an inverting input terminal and PIN3 is non-inverting input terminal. The output of the operational amplifier is the product of the gain and the input voltage. And if the voltage of inverting input (-) is Higher than non-inverting end (+), then output is LOW. When voltage at non-inverting input (+) is higher than the voltage at inverting input (-), then the output of comparator is HIGH. Like if PIN 3 is having +ve polarity then we will get +ve polarity of output from PIN 6. When input source is connected to non-inverting terminal PIN 3 and PIN 2 is feedback with the output PIN 6 then the op-amp is in non-inverting condition. Like if PIN 2 is having +ve polarity then we will get –ve polarity of output from PIN 6. When input source is connected to inverting terminal PIN 2 and feedback with the output PIN 6 then the op-amp is in inverting condition. OUTPUT Voltage = Gain * Input VoltageĪn op-amp can be used in two ways: 1. The LM741 can operate with a single or dual power supply voltage.

Op-amps have large gain and usually used as Voltage Amplifier. The main function of this IC is to do mathematical operation in various circuits. An operational amplifier IC is used as a comparator which compares the two signal, the inverting and non-inverting signal. LM741A, LM741C, LM709C, LM201, MC1439, and LM748Īn LM741 operational amplifier is a DC-coupled high gain electronic voltage amplifier. TO-99 and CDIP - 300 ˚C (for 10 seconds – prescribed).Soldering pin temperature – PDIP package - 260 ˚C (for 10 seconds – prescribed).Operating temperature should be -50 to 125 ˚C.Minimum, normal and maximum Power Consumption for this IC is ☑0v, ☑5v and ☒2v respectively.Prevent from latch-up when common-mode range is exceeded.No external frequency compensation is required.Large common mode rejection ratio (CMRR) and differential voltage ranges.Provided with short circuit and overload protection.LM741 has only one op-amp inside, there are some op-amp IC’s having more than one op-amp like LM358, LM148, LM248, LM348.LM741 Op-Amp IC Features and Specifications Pin used for remove the offset voltage and balance input voltage.

Persamaan ic lm741